$38.00 - VHS

$43.00 - DVD

See the Taig Micro-Lathe perform some of the most unorthodox machining techniques the most thought were impossible. Learn how to make 60-50-40 hole indexing plates and how to use it on the Taig. Get that tail stock set to within a few tenths in a couple of minutes with a simple shop made test bar and TDI. See a heavy-duty motorized cross slide drill rig that will perform any radial drilling as well as milling job. See a 50 division graduated dial being engraved with the use of a simple device. Turn the Taig into a miniature 3 in 1 machining center.

Would you like a graduated carriage lead screw for your Taig? After viewing this production, you will be able to make one in one evening. Learn to make and use several flex shaft milling and grinding units for both the cross slide and the vertical milling attached. How about auto feed for the carriage and cross slide? These are just some of the fun subjects that will be covered in this new and unique production.

By Craftsman, Jose F. Rodriguez
Running Time: Approximately 4 hours

© Copyright Wallender Engineering
Ph: 530-741-9389
Web Site Design by EvieB
www.EvieB.com